Gene's Machine Shop
404-234-9993 horsesaz@yahoo.com
Heavy Industrial Machine Work
Specialty Modifications in Progress
 |
24" Vermeer 850/Poclain Drive Motor Motor had shaft broken off inside and before it broke, it slipped inside the housing and friction welded itself in. Photo illustrates actual boring out of damaged shaft on a Leblond 48" Capacity Sliding Gap Bed Lathe. |
Packing Gland on 850 Vermeer Boom Cylinder Gland was damaged by a bent rod. To repair, we welded/bored out gland and installed 1/4" oversize induction hardened rod. Pictured on a 24" American Pacemaker Lathe. |
|
BEFORE |
AFTER |
 |
 |
| Boring case hardened Vermeer pivot ring to accomodate oversized inner ring on 32" Lodge and Shipley lathe. |  |
 |
Inhouse modification on a Vermeer 750 idler shaft assembly. Replacing snap ring with a much stronger bolt on retainer. This modification is available on 850 and 955 also. |
850 Vermeer Boom Cylinder Barrel with damaged pin bosses Welded and rebored pin bosses on a specially made 180 degree fixture that allows near perfect alignment of pin bosses in relation to cylinder and from one side to the other. Shown on a Cincinnati #5 Mill. |
 |
Regrinding the bore and flats inside a Hoe Ram bit housing that was mis-machined at the factory and then case hardened. Shown using a 22" General Engines Shaper with a grinding attachment. |
|
 |
 |
404-234-9993
24 Hour Emergency Service